2,6-Dimethylpyridin Chemische Eigenschaften,Einsatz,Produktion Methoden
R-S?tze Betriebsanweisung:
R10:Entzündlich.
R22:Gesundheitssch?dlich beim Verschlucken.
R36/37/38:Reizt die Augen, die Atmungsorgane und die Haut.
R20/21/22:Gesundheitssch?dlich beim Einatmen,Verschlucken und Berührung mit der Haut.
S-S?tze Betriebsanweisung:
S26:Bei Berührung mit den Augen sofort gründlich mit Wasser abspülen und Arzt konsultieren.
S36/37:Bei der Arbeit geeignete Schutzhandschuhe und Schutzkleidung tragen.
S16:Von Zündquellen fernhalten - Nicht rauchen.
S36:DE: Bei der Arbeit geeignete Schutzkleidung tragen.
S36/37/39:Bei der Arbeit geeignete Schutzkleidung,Schutzhandschuhe und Schutzbrille/Gesichtsschutz tragen.
Chemische Eigenschaften
Colorless to yellow liquid
Occurrence
Reported found in bread, tea, peppermint oil, cheeses, chicken, beef, pork, beer, sherry, whiskies, cocoa, coffee, tea, oatmeal, rice bran, buckwheat and malt.
Verwenden
2,6-Lutidine is used as a solvent in organic synthesis and as a sterically hindered mild base. It is also used as a vulcanization accelerator for dyes, resins and rubber. It also acts as a food additive.
Definition
ChEBI: A member of the class of methylpyridines that is pyridine carrying methyl substituents at positions 2 and 6.
Allgemeine Beschreibung
A colorless liquid with a peppermint odor. Flash point 92°F. Less dense than water. Vapors heavier than air. Produces toxic oxides of nitrogen during combustion. Used to make other chemicals.
Air & Water Reaktionen
Highly flammable. Soluble in water.
Reaktivit?t anzeigen
2,6-Lutidine neutralizes acids in exothermic reactions to form salts plus water. May be incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides. Flammable gaseous hydrogen may be generated in combination with strong reducing agents, such as hydrides.
Health Hazard
Inhalation or contact with material may irritate or burn skin and eyes. Fire may produce irritating, corrosive and/or toxic gases. Vapors may cause dizziness or suffocation. Runoff from fire control or dilution water may cause pollution.
l?uterung methode
Likely contaminants include 3-and 4-picoline (similar boiling points). However, they are removed by using BF3, with which they react preferentially, by adding 4mL of BF3 to 100mL of dry fractionally distilled 2,6-lutidine and redistilling. Distillation of commercial material from AlCl3 (14g per 100mL) can also be used to remove picolines (and water). Alternatively, lutidine (100mL) can be refluxed with ethyl benzenesulfonate (20g) or ethyl p-toluenesulfonate (20g) for 1hour, then the upper layer is cooled, separated and distilled. The distillate is refluxed with BaO or CaH2, then fractionally distilled through a glass helices-packed column. 2,6-Lutidine can be dried with KOH or sodium or by refluxing with (and distilling from) BaO, prior to distillation. For purification via its picrate, 2,6-lutidine, dissolved in absolute EtOH, is treated with an excess of warm ethanolic picric acid. The precipitate is filtered off, recrystallised from acetone (to give m 163-164.5o (166-167o), and partitioned between ammonia and CHCl3/diethyl ether. The organic layer, after washing with dilute aqueous KOH, is dried with Na2SO4 and fractionally distilled. [Warnhoff J Org Chem 27 4587 1962.] Alternatively, 2,6-lutidine can be purified via its urea complex, as described under 2,3-lutidine. Other purification procedures include azeotropic distillation with phenol [Coulson et al. J Appl Chem (London) 2 71 1952], fractional crystallisation by partial freezing, and vapour-phase chromatography using a 180-cm column of polyethylene glycol-400 (Shell, 5%) on Embacel (May and Baker) at 100o, with argon as carrier gas [Bamford & Block J Chem Soc 4989 1961]. The hydrochloride has m 235-237o, 239o (from EtOH). [Beilstein 20 II 160, 20 III/IV 2776, 20/6 V 32.]
2,6-Dimethylpyridin Upstream-Materialien And Downstream Produkte
Upstream-Materialien
Downstream Produkte
6-Methylpyridin-2-ethanol
2,6-BIS(CHLOROMETHYL)PYRIDINE
Pyridin-2,6-dicarbonsure
3-Bromo-2,6-dimethylpyridine
7-BROMO-1,2,3,4-TETRAHYDRO-ISOQUINOLINE
2,4-Dimethylpyridin
2,6-Dimethyl-3-nitropyridin
5-bromo-1,2,3,4-tetrahydroisoquinoline
Cefpiramide acid
Pyridin-2,6-diyldimethanol
6-BROMOMETHYL-2-PYRIDINECARBOXYLIC ACID
4-Methoxy-7H-furo[3,2-g][1]benzopyran-7-on
2-(Bromomethyl)-6-methylpyridine
2,6-Dimethylpyridin-4-amin
2,6-Dimethylpyridin-1-oxid
6-Methylpyridin-2-carbonsure
2,6-Dimethyl-3-pyridylamin
6-Methyl-2-vinylpyridin
(2S,6S)-2,6-dimethylpiperidine
