Ethenon Chemische Eigenschaften,Einsatz,Produktion Methoden
ERSCHEINUNGSBILD
FARBLOSES GAS MIT CHARAKTERISTISCHEM GERUCH.
PHYSIKALISCHE GEFAHREN
Das Gas ist schwerer als Luft und kann sich am Boden ausbreiten. Fernzündung m?glich.
CHEMISCHE GEFAHREN
Polymerisiert leicht. Reagiert sehr heftig mit vielen organischen Verbindungen. Reagiert mit Wasser unter Bildung von Essigs?ure. Zersetzung in Alkohol und Ammoniak.
ARBEITSPLATZGRENZWERTE
TLV: 0,5 ppm (als TWA) 1,5 ppm (als STEL) (ACGIH 2005).
MAK: IIb (nicht festgelegt, aber Informationen vorhanden) (DFG 2008).
AUFNAHMEWEGE
Aufnahme in den K?rper durch Inhalation.
INHALATIONSGEFAHREN
Eine gesundheitssch?dliche Konzentration des Gases in der Luft wird beim Entweichen aus dem Beh?lter sehr schnell erreicht.
WIRKUNGEN BEI KURZZEITEXPOSITION
WIRKUNGEN BEI KURZZEITEXPOSITION: Die Substanz reizt Augen, Haut und Atemwege. Inhalation des Gases kann zu Lungen?dem führen (s. Anm.). Die Auswirkungen treten u.U. verz?gert ein. ?rztliche Beobachtung notwendig. (s. Anm.)
WIRKUNGEN NACH WIEDERHOLTER ODER LANGZEITEXPOSITION
Risiko der Lungensch?digung bei wiederholter oder l?ngerer Exposition mit nachfolgendem Emphysem und Fibrose.
LECKAGE
Gefahrenbereich verlassen! Fachmann zu Rate ziehen! Belüftung. Pers?nliche Schutzausrüstung: Gasdichter Chemikalienschutzanzug mit umgebungsluftunabh?ngigem Atemschutzger?t.
Chemische Eigenschaften
Colorless gas with a sharp penetrating odor;liquefies at -56°C (-68.8°F); solidifies at-151°C (-239.8°F); soluble in alcohol andacetone, decomposed by water.
Verwenden
For the conversion of higher acids into their anhydrides; for acetylation in the manufacture of cellulose acetate and aspirin.
Vorbereitung Methode
Ketene may be prepared also by pyrolysis of acetic anhydride or phenyl acetate or diketene. Other sources are quite unsatisfactory from a standpoint of yield. Small quantities may be made conveniently by heating acetone in a “ketene lamp.” This is a glass apparatus containing a Nichrome filament, heated electrically to red heat. Larger amounts are made by passing acetone or acetic acid through a tube at 700 °C. A very brief contact time is required, so that much of the acetone is undecomposed and has to be condensed and recycled. Also, it is imperative that the reaction tube be of inert material such as porcelain, glass, quartz, copper or stainless steel. A copper tube, if used, should be protected from oxidation by an iron sheath. Inert packing may be used (glass, vanadium pentoxide, porcelain), but just as good yields are obtained with empty tubes. No catalyst is known which accelerates this decomposition at significantly lower temperatures.
Health Hazard
Ketene is a highly toxic gas. It causes severeirritation to the eyes, nose, throat, and skin.Exposure to 10–15 ppm for several minutescan injure the respiratory tract. It causespulmonary edema. A 30-minute exposure to23 ppm was lethal to mice and a 10-minuteexposure to 200 and 750 ppm caused deathto monkeys and cats.
Brandgefahr
Ketene in its gaseous state should be
flammable and explosive in air. The pure
compound, however, polymerizes readily
and cannot be stored as a gas. Its flash point
and LEL and UEL values are not reported. It
can react violently with oxidizers and many
organic compounds. Its small size and the
olefinic unsaturation impart further reactivity
to the molecule.
l?uterung methode
Ketene is prepared by pyrolysis of acetic anhydride. Purify it by passing through a trap at -75o and collecting in a liquid-nitrogen-cooled trap. Ethylene is removed by evacuating the ethylene in an isopentane-liquid-nitrogen slush pack at -160o. Store it at room temperature in a suitable container in the dark or better at -80o, but do not store it under pressure as it may EXPLODE. It is a strong IRRITANT when inhaled and is as poisonous as phosgene. See diketene in “Heterocyclic Compounds”, Chapter 4. [Hurd Org Synth Coll Vol I 330 1941, Andreades & Carlson Org Synth Coll Vol V 679 1973.]
Ethenon Upstream-Materialien And Downstream Produkte
Upstream-Materialien
Downstream Produkte
