ChemicalBook CAS DataBase List 6-NITROQUINOLINE

6-NITROQUINOLINE synthesis

9synthesis methods

Product Name:6-NITROQUINOLINE
CAS Number:613-50-3
Molecular formula:C9H6N2O2
Molecular Weight:174.16

5332-25-2

613-50-3

GENERAL STEPS: 6-bromoquinoline (0.5 mmol), copper(II) trifluoromethanesulfonate (45 mg, 0.125 mmol), potassium nitrite (KNO2, 128 mg, 1.5 mmol), and anhydrous dimethylsulfoxide (DMSO, 0.6 mL) were sequentially added to a pre-dried oven-dried pressure tube under nitrogen protection. The pressure tube was sealed with a PTFE screw cap with a micro-valve and purged by nitrogen for 5 min to remove air. Subsequently, the reaction mixture was stirred at room temperature for 10 minutes and then gradually warmed up to 130°C and the reaction was continued at this temperature for 48 hours. Upon completion of the reaction, the mixture was cooled to room temperature, washed with excess ice water and extracted with ethyl acetate (3 x 10 mL). The organic phases were combined, dried over anhydrous sodium sulfate (Na2SO4), filtered and concentrated under reduced pressure to give the crude product. The crude product was purified by column chromatography on silica gel (for entries 1-18 in Table 2) or basic alumina (for entries 19-23 in Table 2), using a solvent mixture of ethyl acetate and hexane as eluent, and the target product, 6-nitroquinoline, was finally obtained in good yield.

612-57-7 Synthesis

612-57-7
217 suppliers
$6.00/1g

613-50-3
240 suppliers
$10.00/5g

Yield:613-50-3 97%

Reaction Conditions:

with Tris(3,6-dioxaheptyl)amine;sodium nitrite;tris-(dibenzylideneacetone)dipalladium⁽⁰⁾;t-BuBrettPhos in tert-butyl alcohol at 130; for 24 h;Product distribution / selectivity;Inert atmosphere;

Steps:

54
EXAMPLE FIFTY-FOUR: General Procdure for Pd-Catalyzed Nitrations of Aryl Chlorides and Aryl Sulfonates (Figures 20 and 21); An oven-dried schlenk tube, which was equipped with a magnetic stir bar and fitted with a rubber septum, was charged with the Pd₂(dba)₃ (0.5 mol %), ligand (6, 25, 26, or 27) (1.2 mol %), and NaNO₂ (138 mg, 2.0 mmol) (aryl halides* that were solids at room temperature were added with the catalyst). The vessel was evacuated and backfilled with argon (this process was repeated a total of 3 times) and then the aryl halide* (1.0 mmol), tris(3,6-dioxaheptyl)amine (5 mol %), and te/t-butanol (2 mL) were added via syringe. The reaction vessel was sealed with a Teflon screw cap and heated to 110 ⁰C for 24 h. The solution was cooled to room temperature, diluted with Ethyl acetate, washed with water, and purified via flash chromatography.* Includes aryltriflates and arylnonaflates.

References:

MASSACHUSETTS INSTITUTE OF TECHNOLOGY WO2009/76622, 2009, A2 Location in patent:Page/Page column 144-145

FullText